Most if not all of those square motors are the same dimension and should FIT ok...the only nit would be the shaft length (and diameter?). I think they were all made to a similar size standard so they'd interchange, but again, the shaft length would be the deciding factor. THAT might change. But as long as the shaft length and diameter ( another possible change ) are the same, it should work fine.
Jerry " When life throws you bananas...it's easy to slip up"
Country: USA ~
Posts: 3974 ~
Member Since: January 04 2009 ~
Last Visit: January 11 2019
An HP7 motor will fit. There are two minor issues. The pinion length is a bit short and the contact tabs need to be bent to the outside edge and not the front.
Country: USA ~
Posts: 133 ~
Member Since: January 30 2010 ~
Last Visit: April 07 2019
An HP7 motor will fit. There are two minor issues. The pinion length is a bit short and the contact tabs need to be bent to the outside edge and not the front.
Originally posted by Jeepman - January 05 2011 : 09:02:58 AM
AWESOME!!!
Thanks!
Country: USA ~
Posts: 201 ~
Member Since: March 14 2009 ~
Last Visit: October 28 2012