|
|
 Posted - November 08 2008 : 4:05:19 PM
|
I was working on a PT power truck when I noticed it ran better if I loosened the screws on the bottom of the truck. This seemed to free the axles a bit. This PT had the thicker axles. It was if the bottom of the truck was putting pressure on the axles or axle. At this point the truck bottom is loose and will wobble a bit.
Alco Fan
|
Country:  USA ~
Posts: 2496 ~
Member Since: August 03 2006 ~
Last Visit: September 17 2024
|
Alert Moderator
|
|
|
|
Posted - November 08 2008 : 8:36:38 PM
|
I would check to see if the bottom cover is the right one, or check for casting flash.
You may also be able to shim the bottom cover with thin washers.
Ray
|
|
Country: USA ~
Posts: 1285 ~
Member Since: December 14 2005 ~
Last Visit: May 16 2019
|
Alert Moderator
|
|
|
|
Posted - November 16 2008 : 7:11:20 PM
|
I tried a different truck cover and it helped. Thanks
Alco Fan
|
|
Country: USA ~
Posts: 2496 ~
Member Since: August 03 2006 ~
Last Visit: September 17 2024
|
Alert Moderator
|
|
Home
Forums
Events Calendar
Forum Admins & Mods
Register
