|
Posted - May 07 2016 : 3:05:06 PM
|
I once bought a Bachmann Silver Series tank car. When, some years later, I went to disassemble it, I discovered that the tank halves and frame were secured not via a screw but rather via melting the end of the long pin extending down from the top half of the tank shell. I was wondering if they were still doing it that way.
Feedback-hungry attention w****
|
Country: USA ~
Posts: 750 ~
Member Since: December 05 2015 ~
Last Visit: January 24 2024
|
Alert Moderator
|
|
|
Posted - May 10 2016 : 3:38:25 PM
|
I have only seen that on the tank cars recently. Then again I purchased these at a show so there is no telling if they were new stock or new old stock.
|
Country: USA ~
Posts: 332 ~
Member Since: August 28 2010 ~
Last Visit: April 23 2020
|
Alert Moderator
|
|
|
Posted - May 14 2016 : 8:49:30 PM
|
Well, this purchase was in the early 2000s
Feedback-hungry attention w****
|
Country: USA ~
Posts: 750 ~
Member Since: December 05 2015 ~
Last Visit: January 24 2024
|
Alert Moderator
|
|