|
|
 Posted - February 17 2013 : 12:23:32 PM
|
I'm rebuilding my Varney 4-6-0. Missing the important stuff. I found the screws I need. I decided to make my own side rod spacer. What does the inside diameter need to be? I'm using brass tubing. Bowser has my parts, just want too much for shipping! Also, what washers will work well with 0-80 screws? I notice Micro Mark has only the "Numbered" washers.
" Heck with counting 'em rivets, TRAINS ARE FOR FUN! Not called the Mad Scientist for nothing either!"
Edited by - Redneck Justin on February 17 2013 1:20:53 PM
|
Country:  USA ~
Posts: 3147 ~
Member Since: May 07 2007 ~
Last Visit: June 27 2025
|
Alert Moderator
|
|
|
|
Posted - February 17 2013 : 6:01:30 PM
|
A clearance hole for an 0-80 screw is .06350" in diameter. That's an no. 52 drill bit.
Unspoken expectations are premeditated failures.
|
|
Country: USA ~
Posts: 825 ~
Member Since: December 22 2008 ~
Last Visit: March 16 2015
|
Alert Moderator
|
|
Home
Forums
Events Calendar
Forum Admins & Mods
Register
