|
|
 Posted - June 23 2012 : 7:14:04 PM
|
I have a MAntua 2-8-2 mikado that slips going fwd but runs fine in reverse.
Im thinkin its the worm gear...anyone have or have had this similar problem?
Any help appreciated
Thanx
caboose 1
|
Country:  USA ~
Posts: 352 ~
Member Since: November 09 2010 ~
Last Visit: January 21 2013
|
Alert Moderator
|
|
|
|
Posted - June 23 2012 : 7:30:44 PM
|
Either the worm or worm gear could be cracked, but I've never seen it on those gears. Are you sure the motor is fully seated and the mounting screw is tight?
The Tyco Depot
Edited by - NickelPlate759 on June 23 2012 7:36:10 PM
|
|
Country: USA ~
Posts: 3927 ~
Member Since: June 20 2007 ~
Last Visit: November 19 2015
|
Alert Moderator
|
|
|
|
Posted - June 23 2012 : 7:39:14 PM
|
yes sir...checked the screws...tight!
caboose 1
|
|
Country: USA ~
Posts: 352 ~
Member Since: November 09 2010 ~
Last Visit: January 21 2013
|
Alert Moderator
|
|
|
|
Posted - June 23 2012 : 8:08:12 PM
|
removed motor...installed PROPER screw...did an allignment....going to test run again...
caboose 1
|
|
Country: USA ~
Posts: 352 ~
Member Since: November 09 2010 ~
Last Visit: January 21 2013
|
Alert Moderator
|
|
|
|
Posted - June 23 2012 : 8:39:44 PM
|
Also be sure the axle gear isn't stripped, which will happen if it's allowed to slip.
The Tyco Depot
|
|
Country: USA ~
Posts: 3927 ~
Member Since: June 20 2007 ~
Last Visit: November 19 2015
|
Alert Moderator
|
|
|
|
Posted - June 23 2012 : 9:29:25 PM
|
had it movin for a while but now the brushes are shot...
Thanx for your time...I'll put a new motor in it
caboose 1
|
|
Country: USA ~
Posts: 352 ~
Member Since: November 09 2010 ~
Last Visit: January 21 2013
|
Alert Moderator
|
|
Home
Forums
Events Calendar
Forum Admins & Mods
Register
1 guest.)
