Does anyone out there know where I can buy the small pinion brass or steel drive wheel that was common on the old Tyco Mantua motors? I have some old super 630's that need the gears and some other models that receive the same gear from the motor spindle. Any help at all is appreciated as I have just about exhausted my search. I would prefer the originals, but, after market would work too. I just don't know where to get them. Thanks.
dirtboy45 John S. Cunningham
Country: USA ~
Posts: 41 ~
Member Since: November 17 2011 ~
Last Visit: December 24 2016
Hi You need the ggear that goes on the axle? I may have one also have gears that go on the motor itself ok. post a photo of it and Ill look and see what I have. Steven
Country: USA ~
Posts: 227 ~
Member Since: January 26 2010 ~
Last Visit: May 18 2016
It is on the spindle "axle" that protrudes from the motor. It is usually brass but I have seen them made of steel or some other metal. They usually have only 7 to 8 teeth? I can't be sure on that one. Let me know if this is what you have as I have no picture to show you. Thanks for helping out.
dirtboy45
quote:
Hi You need the ggear that goes on the axle? I may have one also have gears that go on the motor itself ok. post a photo of it and Ill look and see what I have. Steven
Originally posted by steve - December 05 2011 : 5:20:33 PM
John S. Cunningham
Country: USA ~
Posts: 41 ~
Member Since: November 17 2011 ~
Last Visit: December 24 2016
Home
Forums
Events Calendar
Forum Admins & Mods
FAQ
Register
Posted - December 05 2011 : 1:20:16 PM
USA ~
Posts: 
