|
|
 Posted - May 15 2008 : 7:48:53 PM
|
I found another CD player just begging to be scrapped and thought I'd see if I could replace a motor in a Super 630. Actually GiC mentioned the idea in the STC rebuild article.
This CD player by Lenoxx had a very slim motor, so much more than the SRII. Once I readied the block, this time using my Dremel and a cut-off wheel to speed things along. I removed some extra material in the block, to make the motor more flush with the block, and have a very small clearance between the block and the middle axle wheel.
I drilled the pinion slowly and mounted it to the shaft with a little Epoxy as before while having epoxy set up between the motor and the block. I tried to mesh the gears as gently as possible.
I used an empty screw hole and screw to mount the red lead and wired the black to the existing wire from the rear truck. I placed it on the track and it ran.
I've only had this thing together for about an hour. Did I mention that I paid $.25 for the CD player?
BTW There is a pic of the clearenced block and the motor that is in this 630 under Electric Motors in the Tyco Maintenance and Repair Shop.
Alco Fan
Edited by - Alco Fan on May 15 2008 9:14:53 PM
|
Country:  USA ~
Posts: 2496 ~
Member Since: August 03 2006 ~
Last Visit: September 17 2024
|
Alert Moderator
|
|
|
|
|
|
Home
Forums
Events Calendar
Forum Admins & Mods
Register
