I have some shells that need some minor pilot repair. I was going to try cutting the pliot and steps off some of my junkier shells. I have a Dremel tool but I've not had much luck with it. What have ya'll found works the best.
Thanks Jeremy
Country: USA ~
Posts: 164 ~
Member Since: August 01 2007 ~
Last Visit: April 04 2014
I often use the Dremel cutoff discs, and that's what I'd use here.
Everyone laughs about this, but I use a cheap MiniMite hooked up to an old MRC TechII power pack. Gives me all the speed and power I need, and runs nice and smooth.
Country: USA ~
Posts: 108 ~
Member Since: December 25 2007 ~
Last Visit: October 11 2012
Home
Forums
Events Calendar
Forum Admins & Mods
FAQ
Register
Posted - February 19 2008 : 2:01:25 PM
USA ~
Posts: 