|
|
 Posted - January 01 2012 : 10:13:08 AM
|
I have an old loco I am currently pulling down.
I have found that several screws that are used to hold wires to the frames are showing signs of ageing/oxidization. (Structurally they are ok, but they have that oxidizing white blush)
Would like to clean them up as they are part of the power conducting system, but fingers not that nimble to run a small file on them, & they are pretty small.
Anyone use a particular spray or solution that is easy to use & works?
Thanks
TE
|
Country:  USA ~
Posts: 243 ~
Member Since: September 08 2008 ~
Last Visit: January 04 2012
|
Alert Moderator
|
|
|
|
Posted - January 01 2012 : 11:30:56 AM
|
| One time I used a pair of small pliers to hold the screw and a small brass brush to clean them up. As for spray I didn't use any.
|
|
Country: USA ~
Posts: 457 ~
Member Since: February 20 2010 ~
Last Visit: April 24 2020
|
Alert Moderator
|
|
|
|
Posted - January 01 2012 : 8:32:50 PM
|
White vinegar will work, just don't use it if they're blackened.
The Tyco Depot
|
|
Country: USA ~
Posts: 3927 ~
Member Since: June 20 2007 ~
Last Visit: November 19 2015
|
Alert Moderator
|
|
|
|
Posted - January 03 2012 : 3:49:28 PM
|
| A polishing brush in a Dremel will also work, though clearance can be an issue if you don't want to remove the screw.
|
|
Country: USA ~
Posts: 2798 ~
Member Since: September 17 2010 ~
Last Visit: July 22 2015
|
Alert Moderator
|
|
Home
Forums
Events Calendar
Forum Admins & Mods
Register
