|
|
 Posted - February 08 2011 : 11:29:53 PM
|
Hi Folks,
I have a few motors I would to get rid of as follows:
1-PT motor rebuilt and ready to go with all the gears. $15.00
1-PT motor rebuilt with a can motor the will haul like a mule.$20.00
All the can motors are $2.50 each. Some have 1mm shaft others have 2mm shaft all work well after testing.
Thanks.
Ken
FIDDLEHEAD RAILWAY CO.
|
Country:  Canada ~
Posts: 468 ~
Member Since: January 17 2010 ~
Last Visit: February 29 2012
|
Alert Moderator
|
|
|
|
Posted - February 09 2011 : 8:11:54 PM
|
Ken, put me down for the can mounted in the block
Tom
|
Country:  USA ~
Posts: 619 ~
Member Since: February 03 2008 ~
Last Visit: June 07 2023
|
Alert Moderator
|
|
|
|
Posted - February 09 2011 : 9:19:07 PM
|
I would like 2 of your best CD motors. Is 2 mm the length of the shaft? PM me on the details please.
Alco Fan
|
|
Country: USA ~
Posts: 2496 ~
Member Since: August 03 2006 ~
Last Visit: December 06 2021
|
Alert Moderator
|
|
|
|
Posted - February 11 2011 : 8:33:01 PM
|
In have gone through 2 motors I think due to too much voltage going through the motors. When I replaced the motors I also added a resistor on both leads for running in both directions. Are you guys adding resistors in addition to the CD can motors?
Alco Fan
|
|
Country: USA ~
Posts: 2496 ~
Member Since: August 03 2006 ~
Last Visit: December 06 2021
|
Alert Moderator
|
|
|
|
Posted - February 11 2011 : 9:46:34 PM
|
Hi Alco fan,
I have not used any resistors on mine as all my motors are 12v to start with.I use 12v power to test mine and have not had 1 burn out. I let them run for about 5 min if they are going to burn out they would do it with that test!! The power band is great I can just turn on my engine and only the light will come on a little more power and they take off very slow. I cannot run any of mine full out I would have a hole in the wall.LOL
Ken
FIDDLEHEAD RAILWAY CO.
|
|
Country: Canada ~
Posts: 468 ~
Member Since: January 17 2010 ~
Last Visit: February 29 2012
|
Alert Moderator
|
|
Home
Forums
Events Calendar
Forum Admins & Mods
Register
